Products
It consists of 4 sets of cooling towers, all of which are the open type. The cooling water is pressurized by the circulating water pump and is then sent to the heat exchanger at each production device for heat exchange. After that, the circulating water is sent to the top of the cooling tower through the residual pressure; through the heat exchange between the water and the gas pumped by the fan at the top of the tower, the cooled water flows into the pool and is then pressurized and sent out by the circulating water pump for cyclic use.
发电装置在运行过程中产生部分蒸汽,除系统消耗一部分外,还富蒸汽数量比较大、品位相对比较低(饱和),经分析和论证,采用上两套12MW补汽凝汽式汽轮机,将这部分余热蒸汽能量充分予以利用,每小时可以产生约10KV的电量1.2KWH/套,并入装置的10KV电网,既大大减少了外引电的数量,同时又将所有蒸汽冷凝成水回收利用,还减少了对环境的排放噪音污染。
Steam is generated during the operation of the power generation device, in addition to the part consumed by the system, there is a relatively large amount of residual steam, with a relatively low grade (saturation). Through the analysis and demonstration, the last two 12MW steam-supplementing and condensing turbines are used to fully utilize the waste heat of the residual steam, as a result, about 10 KV power (1.2 KWH/set) is generated per hour and is supplied to the 10 KV power grid of the unit, thus greatly reducing the external electricity, condensing all the steam into water and recycling it, and also reducing the noise pollution to the environment.
GE水煤浆气化采用GE技术,分别在2007年4月和2009年9月投产,共7台气化炉,5开两备,出产的气体经变换送低温甲醇洗。灰水经渣水处理系统洗的回收利用。粗渣经承包商外送处理。
Water-coal slurry gasification unit
The unit, for which the GE technology is adopted, was put into operation in April 2007 and September 2009, supplying materials to 7 gasification furnaces, 5 for operation and 2 for standby, and consuming tons of coal per year, and the gas produced is sent to the low-temperature methanol washing unit after the conversion; the ash water is washed and recycled by the slag water treatment system, and the coarse slag is transported out by the contractor for treatment.
采用美国UOP公司开发的甲醇制取低碳烯烃技术(MethanolToOlefin,简称MTO工艺技术),采用配套MTO-100催化剂(SAPO-34),由惠生工程(中国)有限公司负责详细设计与承包。装置甲醇为原料,设计规模为甲醇处理量75万吨/年,主要由进料和产品分离、反应和再生、催化剂回收系统、产品压缩和产品浓缩等单元构成,具有规模大、人员少、工艺先进、联合程度深以及设备国产化程度高等显著特点。
The methanol-to-olefin (MTO process for short) technology, developed by UOP, is adopted, and the supporting MTO-100 catalyst (SAPO-34) is used; Wison Engineering (China) Co., Ltd. is responsible for the detailed design and contract. The methanol is used as raw material for the unit, with a design treatment capacity of 750,000 t/year. The unit is mainly composed of the feed and product separation, reaction and regeneration, catalyst recovery systems, product compression and product concentration plants. featuring large scale, less personnel required, advanced technology, high integration degree and localization degree.
采用WISON公司的烯烃分离技术,该技术是WISON独立开发的具有自主知识产权的先进技术,该工艺采用预切割-油吸收分离技术取代传统深冷脱甲烷系统,流程简单,设备投资少,能耗低。生产28.6万吨/年聚合级乙烯和聚合级丙烯。
The olefin separation technology, an advanced technology independently developed by Wison with independent intellectual property rights, is adopted, and the pre-cutting - oil absorption and separation technology, with simple process, less equipment investment and low energy consumption, is used to replace the conventional cryogenic demethanization system, and to produce 286,000 t/year of polymer-grade ethylene and polymer-grade propylene.
采用道达尔石化公司和UOP公司联合开发的烯烃裂解技术(OlefinCrackingProcess,简称OCP工艺技术)和选择性加氢技术(SelectiveHydrogenationProcess,简称SHP工艺技术),采用配套OCP裂解催化剂、SHP加氢催化剂。项目由惠生工程(中国)有限公司负责详细设计与承包建设。装置以MTO和OPU装置的C4-C8重烯产品为原料,生产以乙烯、丙烯为目标组分的轻烯
The olefin cracking process (OCP process) and selective hydrogenation process (SHP process), jointly developed by Total Petrochemicals and UOP Company, are adopted, and the supporting OCP cracking catalyst and SHP hydrogenation catalyst are used. Wison Engineering (China ) Co., Ltd. is responsible for the detailed design and contract construction of the project. The C4-C8 heavy olefin products from MTO and OPU units are used as raw materials for the unit, to produce light olefin products with ethylene and propylene as target components. The unit is mainly composed of the selective hydrogenation, olefin cracking, regeneration gas compression cycle, cracking gas compressor and regeneration gas compressor, and other sections, and it has various noticeable features, such as many units, large scale, few personnel required, advanced technology, high integration degree and localization degree.
采用由DAVY/DOW联合开发的第二代丙烯铑法低压羰基合成技术-液相循环工艺,年产25万吨丁辛醇。主要产品为辛醇,异丁醛,正异丁醇,这些事重要的化工原料,主要用于生产塑料和橡胶的塑化剂等。